COMPARISON OF DISPERSION CURVES ACQUIRED USING MULTICHANNEL ANALYSIS OF SURFACE WAVES WITH VARIOUS STRIKER PLATE CONFIGURATIONS

Abstract

There is growing appreciation and research regarding geophysical methods to evaluate near surface soil properties in geotechnical engineering. Geophysical methods are generally non-destructive test (NDT) methods that do not necessitate traditional sampling of soils. Instead, they rely on application of input signals and deduction of soil properties from the measured response of the domain. Geophysical methods include various seismic, magnetic and nuclear techniques applied at the surface and/or subsurface within boreholes. Surface seismic methods, which include Multichannel Analysis of Surface Waves (MASW), are increasing in usage for geotechnical engineering purposes to evaluate stiffness properties of soils. MASW typically involves using a hammer to impact a base plate (also referred to as a striker plate) to transmit surface waves into the ground. These waves propagate through the underlying soils at a site and are received by an array of geophones placed on the ground surface. The manner in which the waves propagate is primarily influenced by soil stiffness, particularly against shear. Therefore, the signals recorded during an MASW survey can be analyzed to estimate the shear stiffness of the soils at a site, a parameter that is extremely important for seismic-related engineering purposes (e.g., site amplification, liquefaction, etc.). Aluminum plates are routinely used in a large number of MASW studies as a striker plate to couple the energy from a sledgehammer blow to the underlying soil layers. Various researchers have postulated that the material make-up of the striker plate has an effect on the frequency of the generated waves and, for that matter, the depth achieved with a typical MASW survey. For example, a less stiff material such as ultra-high-molecular-weight (UHMW) polyethylene is often recommended to increase low frequency energy of the input surface wave relative to aluminum. However, very limited research work has been performed in this area to systematically ascertain the effects of modifications to the striker plate material. Due to the limited direct research related to striker plates, MASW was utilized in this study to measure the dispersion curve resulting from MASW at various sites in the Philadelphia metropolitan area. Different striker plate configurations were used during testing to systematically quantify their effects on typical MASW results. The proposed striker base plate configurations included a one (1.0) inch thick aluminum plate, a one (1.0) inch thick aluminum plate over additional rubber mats of varying thickness, and multiple ultra-high-molecular-weight (UHMW) polyethylene plates of various thicknesses. The purpose of this testing was to examine the performance of each configuration, particularly at the low frequency range of the dispersion results. Also efforts were made to qualitatively access the durability of the configurations with respect to long term exposure to impact load.